LogoLogo
  • Welcome
  • Getting Started
    • Quickstart Guide
    • Features
    • Board Overview/Connectors
    • How the System works
      • Firmware Menusystem
      • Motion Operation
      • Service Menu
      • Settings Menu
        • Filter Settings
        • Actuator Settings
        • System Settings
        • Rig Settings
      • Motion Submenu
      • Quick Access Options
    • Button Boxes & Handhelds
    • Setup your Motion Rig
      • Configuration Form
      • Rig
      • Actuators
        • Rotating Actuators
        • Linear Actuators
        • Belt Tensioner Actuators
        • Custom Actuators
        • Endless slew Actuators
      • Pulse Frequency
      • Filters
      • Setup
      • Service / Testing
      • Factory Resets
      • Firmware Updates
      • Direct Motion Mode
      • Position Motion Mode
      • Network
  • Wiring
    • Wiring Online Switch & Safety Stop
    • Wiring Position End Switch for Homing
    • Wiring a Servo Brake
  • Servo Driver Settings
    • Wiring Driver
    • AASD Monitoring Parameters
  • NEW! AASD Servo Torgue Mode for Belt Tensioner
  • FAQ and Troubleshooting
    • Troubleshooting Controller Boot Issues
  • Motion
    • How motion cueing works
    • Dashboard Motionsystem
    • Simtools
    • Flypt Mover
    • DR Sim Manager
    • SimHub
  • Information
    • Serial Commands
    • Communication and Electronics Gear Settings
    • Board Revisions
  • Youtube
  • Discord
  • Github
  • Instagram
  • Terms of Service
  • Privacy Police
Powered by GitBook
LogoLogo

Copyright © Motion4Sim LLC 2024

On this page
  1. Wiring

Wiring a Servo Brake

PreviousWiring Position End Switch for HomingNextServo Driver Settings

Last updated 2 months ago

Internal Servo Brake Control Logic:

Utilize the controller's built-in logic to manage servo brakes through an external relay setup. This allows for precise control and integration into your system's braking mechanism. check this chapter for the brake connector layout and pin descriptionoption:

Brake Connector Layout and Pin Description

The board supports two different types of brake connections. These connections operate in opposite modes, providing flexibility in configuring the braking mechanism as per your system's requirements. Refer to the setup section for instructions on configuring the behavior of these connections.The pins are 5 volts tolerant and can deliver approximately 20mA of current. Please keep this in mind when selecting your external relays and circuits.

Usually, the boards are delivered without the connectors installed. If you need a connector, please inform us before placing your order.

please also checkout the servo brake solution from @KLS

Board Overview/Connectors
: Brakes
brake connectors possible
Logo