LogoLogo
  • Welcome
  • Getting Started
    • Quickstart Guide
    • Features
    • Board Overview/Connectors
    • How the System works
      • Firmware Menusystem
      • Motion Operation
      • Service Menu
      • Settings Menu
        • Filter Settings
        • Actuator Settings
        • System Settings
        • Rig Settings
      • Motion Submenu
      • Quick Access Options
    • Button Boxes & Handhelds
    • Setup your Motion Rig
      • Configuration Form
      • Rig
      • Actuators
        • Rotating Actuators
        • Linear Actuators
        • Belt Tensioner Actuators
        • Custom Actuators
        • Endless slew Actuators
      • Pulse Frequency
      • Filters
      • Setup
      • Service / Testing
      • Factory Resets
      • Firmware Updates
      • Direct Motion Mode
      • Position Motion Mode
      • Network
  • Wiring
    • Wiring Online Switch & Safety Stop
    • Wiring Position End Switch for Homing
    • Wiring a Servo Brake
  • Servo Driver Settings
    • Wiring Driver
    • AASD Monitoring Parameters
  • NEW! AASD Servo Torgue Mode for Belt Tensioner
  • FAQ and Troubleshooting
    • Troubleshooting Controller Boot Issues
  • Motion
    • How motion cueing works
    • Dashboard Motionsystem
    • Simtools
    • Flypt Mover
    • DR Sim Manager
    • SimHub
  • Information
    • Serial Commands
    • Communication and Electronics Gear Settings
    • Board Revisions
  • Youtube
  • Discord
  • Github
  • Instagram
  • Terms of Service
  • Privacy Police
Powered by GitBook
LogoLogo

Copyright © Motion4Sim LLC 2024

On this page

FAQ and Troubleshooting

PreviousNEW! AASD Servo Torgue Mode for Belt TensionerNextTroubleshooting Controller Boot Issues

Last updated 2 months ago

My Handheld Display is switches on and off

If the handheld display turns on and off at certain stages during operation by the encoder, then an option for the RGB display in the setup is enabled. The solution is to deactivate this option.To do this, go to the setup-tab on the dashboard config form, and deactivate the Checkbox "RGB-LCD-installed".